Tools

The Milwaukee-Eight« engine returns to the single camshaft design, which requires a new tool for correct and accurate replacement of the camshaft inner needle bearing Uses the proven JIMS« style remover collet and fine threaded installation driver Holds...

Some wrist pin bushings will require a small amount of ball honing to give specified fit (see H-D manual for specifications). Used to ream wrist pin bushings to the proper inner diameter Can be used with rods in or out of the motor Lead-in taper makes it...

Used to remove inner cam bearing without damaging the crankcase Tool is also designed to keep rollers from falling into the crankcase Comes with instructions Made in the U.S.A.. TOOL INNER CAM BRG 07-17

Used to install bearing race straight into the left crankcase A must for late-model cases Made in the U.S.A.. TIMKEN BEARNG RACE INSTER

Accurately installs and removes lubed ball bearing into transmission trap door No arbor press needed Made in the U.S.A.. TOOL TRAPDOOR BRG 6SPD

Used to install the main drive gear without removing the transmission Made in the U.S.A.. MAIN DRV GEAR TOOL 5-SPED

Removes kick starter clutch gear successfully, without damage to the gear Made in the U.S.A.. M/SHFT CLUTCH GEAR TOOL

Tool is used to remove the sprocket shaft Timken« bearing on late '86-'02 Big Twins with an integral sprocket shaft Does the job better than anything else on the market Made in the U.S.A.. SPRK SHAFT BEARNG TOOL BT

Used to remove and install the inner bearing race on the transmission mainshaft Made in the U.S.A.. MAINSHFT BRNG RACE TOOLBT

Allows installation of delicate, silicone cleveblock bushings in swingarm without damage Tool presses on outer sleeve of bushing Can be used with or without a press. FXR/FLT S/ARM BUSH TOOL

Once the camshafts are removed from the support plate this tool will remove the bearing from the camshaft Removes bearing straight without binding or slipping Made in the U.S.A.. CAM BRG PULLER TWIN CAM

Use to ream rocker bushings to a factory fit of .0007ö - .0012ö in line with each other This precise line reamer is capable of a 24 finish or better Made in the U.S.A.. RCKR BUSH REMR 66-17 TC