Tools

Safely removes and installs the upper spherical bearing on rear shocks Reversible puller cup with cutaway fits a wide variety of shock reservoir and compression adjuster configurations Fits 24 mm OD bearings Durable brass thrust washer. TOOL SHOCK...

Used for removal of the flywheel or rotor if applicable Laser etched with Motion Pro logo and part number Heat treated for strength and durability Durable hot black oxide finish Comes with protector Right hand thread Lifetime limited warranty. TOOL...

Hex socket extends only part of the way into the socket to allow the nut to be held flush with the end for easier, hands-free starting Deep sockets allow nuts to be driven over long threaded bolts Slim outside diameter allows sockets to fit in tight...

3/8" (EU: 0,95 cm) drive male and 1/4" (EU: 0,64 cm) drive female for use with sockets for smaller front axles 3/8" (EU: 0,95 cm) square drive is rated for a maximum torque of 90 lb/ft (EU: 122,02 NM) Allows T-6 Combo LeverÖ to be used as a 3/8" (EU:...

Can be used to remove and replace small to medium internal snap rings up to 50 mm deep, including those used for transmission gear locating, bearing retention, and oil seal retention Allows removal of internal snap rings used in hydraulic master...

The tool is slotted to allow removal and replacement of caps with the P/N 11-0081 Micro BleedersÖ This tool allows removal and replacement of the accessory fork cap Versatile design features a 22 mm hex and 3/8" square drive. KTM FORK CAP REMOVER

Used for removal of the flywheel or rotor if applicable Laser etched with Motion Pro logo and part number Heat treated for strength and durability Premium quality high carbon steel Durable hot black oxide finish Right hand thread Comes with M14 cap...

Includes one 8-1/2" tire iron, one 11" tire iron and one 15" double compound curved tire iron. TOOL 3-TIRE IRONS 8-11-15

Five thread sizes in one tool: M10 x 1.0, M10 x 1.25, M12 x 1.0, M12 x 1.25 and M14 x 1.0 Tool design allows for effortless retrieval of damping rod after spring installation Rod includes downward-facing bleed port to prevent oil splatter Perfect for...

Fits '14 KTM XC models and all '13-'14 Husaberg with WP 4860 4CS fork For removing and installing left hand and right hand adjustable fork caps Allows proper torque of the fork cap assemblies during installation 19 mm hex head Laser engraving Caution:...

Brass blade (included) safely removes paper gaskets from aluminum engine cases Narrow slant-cut blade designed specifically for small, thin engine cases Steel blade included for difficult-to-remove paper gaskets Ergonomic handle with convenient blade...

For removing the fork cap (cartridge) on dual-chamber closed-cartridge forks CNC machined for precise fit and tolerance Laser engraved markings Original Motion Pro design. TOOL 50/14MM FORK WRENCH