Tools

Fits the straight-slot timing plugs on most motorcycles and ATVs Blade sizes are 16 mm (5/8"), 22 mm (7/8") and 38 mm (1-1/2"). TIMING PLUG WRENCH

Open-end design allows for removal of clevis and service to rebound adjuster without disassembly of shock Designed for removal of oval-profile clevis jam nut common on WP shock absorbers Durable heat-treated alloy steel construction. TOOL SHOCK JAM NUT...

Stronger 38 mm wide strap for improved grip and durability For use with 3/8" drive ratchet or extension Maximum strap diameter 125 mm (5") Fits all spin-on type oil filters. TOOL FILTER STRAP WRENCH

Used for removal of the flywheel or rotor if applicable Laser etched with Motion Pro logo and part number Comes with 4 mm, 5 mm, 6 mm hardware Heated treated for strength and durability Premium quality high carbon steel Durable hot black oxide finish...

One tip is shorter and notched to be placed on the pin, which allows the longer end to push the clip Designed to simplify installation and removal of clip-type masterlinks. MASTERLINK PLIERS

Works on most control cables with 4 mm to 8 mm outside diameter housing Original design that seals completely around the cable housing Makes it easy to clean and lubricate control cables Less mess and minimal wasted lubricant Best if used with Motion Pro...

Motion Pro Pinklaw Push Pin Tool 80766. PinKlaw Push Pin Tool

Use wrench on external hex of tool for situations exceeding 150 lb/ft (EU: 203,37 Nm) 3/8" (EU: 0,95 cm) square drive on both ends rated to 150 lb/ft (EU: 203,37 Nm) Fits internal hex on many late model sportbike axles and some dirt bikes Four metric hex...

Double ended wrench can be used for removal of the compression stack Can be used for removal of a compression stack on late-model RMs For removing the caps on Showa MX forks. TOOL 46/50MM FORK WRENCH

Includes 6 mm hex for main jets, long-reach straight slot for pilot jets and a 3 mm Allen for removing the float bowl Contains longer bits for reaching into recessed cavities to adjust Keihin FCR carburetors Ideal for trail riders and garage mechanics...

To remove and replace the rear wheel bearing / seal retainer rings, part numbers 41231-KZ4-J20 and 41231-KS6-700 Precision design prevents damage to the retainer ring after peened stakes have been removed by drilling Durable hot black oxide finish For...

Economical pliers easily work with both inside and outside opening snap rings or clips Includes three extra sets of tips: one additional straight tip and two offset or angle tips. M.P. SNAP RING PLIERS