Tools

Designed to remove and replace the right crankcase bearing Press bearing in and out straight with no damage to the case Made in the U.S.A.. C/SHAFT BRG TOOL TWIN CAM

Used to remove inner cam bearing without damaging the crankcase Tool is also designed to keep rollers from falling into the crankcase Comes with instructions Made in the U.S.A.. CAM BRG PULLR 58-99 BT

Removes the main drive gear from the main bearing correctly while in the transmission case Eliminates the need of an arbor press and the risk of case damage. TOOL MAIN GEAR INSTL6SPD

Not only removes the left and right main bearing without damaging the case, it also provides correct alignment and depth during installation High levels of precision and accuracy are necessary, so only the best tools can be trusted Main bearing remover...

Remove hex nut from end of main drive gear that secures the rear drive transmission pulley Inner collar will retain wrench to nut for safer work Extra-long two-piece design Made in the U.S.A.. CNTR SHFT LCKNT TL36-06BT

Remove hex nut from end of main drive gear that secures the rear drive transmission pulley Inner collar will retain wrench to nut for safer work Extra-long two-piece design Made in the U.S.A.. TOOL MAIN DR GEAR 07-17BT

For 7 mm valve guides Harley-Davidson« No. 16461-02 that are used in conjunction with the latest conical (Beehive) valve springs Will also work on equivalent aftermarket 7 mm valve guides Quality pilot lead-in reamer Made in the U.S.A.. TOOL REAMER VLV...

Sleeve is several times stronger than stock aluminum case material that standard bearings ride in Replacement sleeve kit for Timken« Case Bearing Tool. SLEEVE KIT F/3801-0084

Make working on motors easier with better access Made in the U.S.A.. ENGINE STAND F/57-99 XL

Easily presses the inner cam bearing smoothly into the right case with the cases assembled to the proper depth Made in the U.S.A.. CAM BEARING INSTALR

Harley-DavidsonÆs« new 6-speed transmission is a very stout piece of engineering, incorporating some of the best bearings made JIMS« has developed a driver style seal installer (not a pushing or pulling type, which could damage these bearings) Installs...

Tool fits any dual rate or conical valve spring with an O.D. no larger then 1.6ö diameter Works with bench vise, arbor, screw hydraulic or drill press 0 to 1000 P.S.I. gauge Made in the U.S.A.. TOOL VALVE SPRING TESTER