Tools

Used to install bearing race straight into the left crankcase A must for late-model cases Made in the U.S.A.. TIMKEN BEARNG RACE INSTER

Used to install the main drive gear without removing the transmission Made in the U.S.A.. MAIN DRV GEAR TOOL 5-SPED

Removes kick starter clutch gear successfully, without damage to the gear Made in the U.S.A.. M/SHFT CLUTCH GEAR TOOL

Used to remove and install the inner bearing race on the transmission mainshaft Made in the U.S.A.. MAINSHFT BRNG RACE TOOLBT

Allows installation of delicate, silicone cleveblock bushings in swingarm without damage Tool presses on outer sleeve of bushing Can be used with or without a press. FXR/FLT S/ARM BUSH TOOL

Once the camshafts are removed from the support plate this tool will remove the bearing from the camshaft Removes bearing straight without binding or slipping Made in the U.S.A.. CAM BRG PULLER TWIN CAM

Use to ream rocker bushings to a factory fit of .0007ö - .0012ö in line with each other This precise line reamer is capable of a 24 finish or better Made in the U.S.A.. RCKR BUSH REMR 66-17 TC

Accurately and safely install the inner balancer bearing mounted in the left engine case All done on a work bench without using an arbor press Designed for early or late Beta« cases Made in the U.S.A.. TOOL INSTL INR BAL BRG

Install or remove the closed-end countershaft bearing on all 5-speed or 6-speed transmissions without using a press or tapping it in with a transmission shaft Designed to install the bearing squarely and to the proper depth Made in the U.S.A.. TOOL 5&6...

This tool can only be used for removing the flywheel from the left case Will also press cases apart and break sealant bond Some case pressing will require a hard cap Use to press flywheels from cases Made in the U.S.A.. CRNK ASSY REMVL TL 55UPBT

Consists of a vacuum-bleed device with a transparent cap which forms a tight seal to the master cylinder and has a fitting to attach a vacuum pump Cleaner way to purge the system of air with less fluid used and a reduced chance of cosmetic damage due to...

Some wrist pin bushings will require a small amount of ball honing to give specified fit (see H-D manual for specifications). Used to ream wrist pin bushings to the proper inner diameter Can be used with rods in or out of the motor Lead-in taper makes it...