Tools

Gives a much better feel than a press while eliminating the possibility of applying too much pressure to the parts Provides precise installation and eliminates the cumbersome task of performing the installation in a press Made in the U.S.A.. TOOL INNER...

For use on Milwaukee Eight series engines. TOOL LT MAIN SEAL RMVR 88

Assists engine rebuilder to clear jet of all assembly lubes; verifies psi number the jet switches to "on" and visualizes spray pattern before cases are sealed Helps determine if piston jet is stuck open or stuck closed Does not include piston jet shown...

Removes both the front and rear counter-balancer shaft bearing assembly, from the left engine case Designed for the 96" and 110" Beta« engines Made in the U.S.A.. TOOL BAL SHAFT 07-08 ST

Safely installs new main transmission case bearing; does not remove bearing Holds bearing square to its bore, eliminating any marring of bearing bore Made in the U.S.A.. TOOL MAIN GEAR 07-17 BT

Comes with new valve collar receiver for safer tool usage, and can be clamped in vice Hardened ball bearing style tip at valve head end eliminates damage to valve This tool is necessary for removing or installing valves Made in the U.S.A.. VALVE SPRING...

Used on '84-'02 Big Twin to install the flywheel assembly to the left crankcase Timken« bearing Made in the U.S.A.. SPKT SHFT BRNG INST TOOL

Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case Will set bearings .023"-.028" below case surface Use to install the two inner cam bearings Made in the U.S.A.. TOOL CAM BRG INST 99-17TC

Secures saddlebag latches and hinges with rivets while providing a clean factory look Made in the U.S.A.. TOOL SADDLEBAG RIVET

This multi-function tool will remove and replace front and rear camshafts and the ball bearings in the Twin Cam 88 It provides the precision alignment of the camshaft to ensure a smooth press in and out of the support plate Made in the U.S.A.. CAM REMOV...

Designed to remove and replace the right crankcase bearing Press bearing in and out straight with no damage to the case Made in the U.S.A.. C/SHAFT BRG TOOL TWIN CAM

Use on '55-'76 XL and K models to install the flywheel assembly into the left crankcase Timken« bearing Optional sleeves sold separately for use on '86-'03 XL and '94-'03 Buell Made in the U.S.A.. SPKT SHFT BRNG PRESS TOOL