Electrical

AMP Multi-Lock connectors are direct Harley-Davidson replacements These non-waterproof connectors are used on every factory model Includes all necessary wire seals, wedgelocks and crimp terminals Includes eight 8-position plugs, eight 6-position plugs,...

AMP Multi-Lock connectors are direct Harley-Davidson replacements These non-waterproof connectors are used on every factory model Includes all necessary wire seals, wedgelocks and crimp terminals Includes eight 8-position plugs, eight 6-position plugs,...

Connect directly to the vehicle allowing users to add additional lighting or any electrical items without CAN/Bus interference Made in the U.S.A. POWER TAP PIGTAIL 2-PACK

Plug-and-play installation Plugs into OE tail light harness Power wire: Brake, tail and ground Includes cable ties and heat shrinkable butt connectors Made in the U.S.A.. HARNESS R.LIGHT/LIC/WHIP

Allows the use of OEM rear fender & rear turn signal bar without the use of the fender tip tri bar light 100% Plug-n-Play. HARNESS TRIBAR ELIM

Allows for easy relocation of speedometer and indicator lights when installing taller risers and using the stock speedo/indicator lamp bracket. 15" long OEM wire colors with male and female terminals installed Rider must de-pin OEM Molex connector for...

Replacement rear fender foam loom with adhesive tape, cut to 18" long This kit will replace the OEM loom for (2) motorcycles. LOOM REAR FENDER 18"

Features all of the wire, heat shrink and Lightning Splice's needed to make adding on additional LED lighting simple Ground, running light, brake light and turn signal wiring for a left and right side light included. HARNESS REAR FENDER

Allows for use of passing lamps while high beam is on Plug and play. HARNESS PASSING LAMP

Get power to the back of the bike without splicing into the existing wiring harness Uses OEM connectors and provides 4" of ground and 12V switched power Power is supplied using the accessory circuit from the factory harness Universal applications...

A must when installing taller handlebars Intended for front turn signals mounted on handlebar switch housings De-pin factory harness connector and install No crimping necessary Made in the U.S.A.. WIRE EXT TURN SIGNAL +4"

Can be used in custom applications Manufacturer's color of connector may vary. SELS WIRE MT SERIES 50PK