Tools

Top-quality replacement sensor Also works on any aftermarket transmission case with a speedometer sensor hole Includes O-ring, hardware and OEM connector Made in the U.S.A.. ELEC.SPEEDO SENSOR FXST

Top-quality replacement sensor Also works on any aftermarket transmission case with a speedometer sensor hole Includes O-ring, hardware and OEM connector Made in the U.S.A.. ELEC.SPEEDO SENSOR FLT

Easily remove the balancer bearings in both Touring and Softail models without damage to the crankcase. TOOL REMOVER M8 BAL BEAR

Installs lower leg 49 mm fork seals squarely into the bore without damaging the seal lip surface Designed for specific Harley-Davidson« models except inverted fork models Two-piece design to aid in some assembly applications Also installs dust shield...

Used to remove or install clutch components Made in the U.S.A.. CLUTCH SPRNG COMP 71-84XL

This tool checks alignment of Big Twin transmission shift forks Made in the U.S.A.. SHFT FRK GAGE 39-78 BT

Assembly includes plate, spring, pawl plate, shifter shaft, spring, pin, washer and retaining ring Reduces shifter free play Made in the U.S.A.. SHIFT PAWL ASSY 85-00 BT

Used to hold flywheel assembly in vise, with or without left case attached Made in the U.S.A.. SPROCKET SHAFT HOLDER

Can be used on most one-piece fuel tanks that use 5/16" or 3/8" hardware to mount fuel tank to motorcycle frame Securely holds or displays fuel tank when mounted to wall stud Made in the U.S.A.. MOUNT WALL FUEL TANK MC

Slip the dog bone end of tool into the bottom side of connector until it is touching the back end of connector box Then gently pull out the male wiring connector and tool Safely removes ignition switch wiring connector Made in the U.S.A.. TOOL IGN SWITCH...

Will position the seal evenly into the exhaust port of head Tool can be used with exhaust flange nuts Made in the U.S.A.. EXHAUST DRILL PLATE

Mounts in vise to hold fork firmly during repair without causing damage to fork assembly Holds fork legs and tubes for easy hands-free servicing or rebuilding Use on smaller 28 mm or larger fork tubes with a maximum 2ö Will not scratch finish Made in the...