Tools

The Quick Connect Nitrogen Hose has special 800 psi (EU: 55,16 Bar) "finger tight" 1/4" (EU: 0,64 cm) flare nut quick couplings This simple assembly works perfectly with our Nitrogen Regulator and Gauge. TOOL, NITROGEN HOSE

A must for all suspension work Holds fork damping rods, cartridges, shock shafts Unique design allows installation of dowels into the top of the vise jaws The holding tools hang on the dowels instead of dropping on the ground when the vise is opened...

A must for all suspension work Holds fork damping rods, cartridges, shock shafts Unique design allows installation of dowels into the top of the vise jaws The holding tools hang on the dowels instead of dropping on the ground when the vise is opened...

With a tap of a hammer, the taper wedges into the ID of most Damping Rods, late model and vintage Designed to make spinning damper rods easier to remove. DAMPING ROD HOLDING TOOL

Unique design works on multiple sizes of fork caps. FORK CAP WRENCH 48MM

Allows easy removal and installation of shock seal assemblies. TSSS-02 SHOCK SEAL TOOL

Allows easy removal and installation of shock seal assemblies. SHOCK SEAL HEAD SET TOOL

Designed to remove and install the seal head assembly from the inner fork tube It allows changing fork springs without disassembling the valving stack It is reversible and has two hex sizes for the two sizes of forks For Showa BPF forks. CARTRIDGE...

Offers users a better way to turn the clickers and remove the compression adjuster during assembly Allows removal of the fork compression adjusters. FORK COMPRESSION TOOL

Unique design works on multiple sizes of fork caps. FORK CAP WRENCH 46/50MM

Four sizes (17 mm, 19 mm, 22 mm and 24 mm) Fits many sport and dirt bikes. TOOL HEX AXLE

Removes the Compression Needle from the shock body on early KTM WP PDS shocks Required to install a SWCN 10 Telescopic Needle (15.0 pin spacing x 2.4mm pins). TOOL,PIN WP PDS