Belt Drives Ltd.

1-1/2" and 1-5/8" kits include front pulley, belt, clutch hub, clutch basket and aramid clutch set (consists of two half plates, four full plates and five steel drive plates) Direct bolt-in...

For use on BDL Belt Drive clutches. GEAR,STARTER PINION 3.25"

For use on BDL Belt Drive clutches. GEAR,PINION,+1",PG-100A

Standard equipment with all of BDL's 2" SS series primary drives Converts existing clutches to a ball-bearing lockup design Lockup design applies extra pressure to the clutch plates for positive...

Standard equipment with all of BDL's SS series primary drives Converts existing clutches to a ball-bearing lockup design Lockup design applies extra pressure to the clutch plates for positive...

61 tooth basket 39 tooth front pulley 8mm x 1-1/2" 132-tooth primary belt Kick start only basket For use with splined engine shaft manufactured from 1955-2006. BELT DRIVE KIT CL 55-64

39 tooth front pulley 61 tooth rear basket 8mm x 1-1/2" 132-tooth primary belt Kick start only basket For use with tapered engine shaft manufactured from 1936-1954. BELT DRIVE KIT CL 36-54

For use on BDL Belt Drive Clutches. PLATE PRESSURE 3" DRIVES

Plates measure 25% wider than the OEM plates for a significant increase in the clutch area Stack height is pre-set for easy installation Can be used in wet or dry clutches Made in the U.S.A.. PLATES...

Plates measure 25% wider than the OEM plates for a significant increase in the clutch area Stack height is pre-set for easy installation Can be used in wet or dry clutches Made in the U.S.A.. PLATES...

For use on BDL Belt Drive clutches. C-CLIP F/BACK SIDE OF HUB

For use on BDL Belt Drive clutches. C-CLIP FOR HUB BEARING