Engine

An economical solution for stock rebuilds, and mild performance upgrades Forged from 8620 steel for greater strength than stock or cast steel Feature the same .750" long rocker shaft bushings as S&S Roller Rockers: longer bushing provides 50% more load...

A four-gear set is required for gear-driven cams that do not come with secondary cam gears; includes two secondary cam gears, outer cam drive gear, outer pinion drive gear and mounting hardware Due to the inherent characteristics of gear drives, you may...

Features revolutionary design - allows quicker, easier installation without the removal of the rocker covers .4375ö diameter Chromoly steel Threaded adjuster screws into the pushrod until the threads disengage and the adjuster simply slides into the...

Kit includes four S&S Quickee pushrods, four pushrod covers and O-rings Pushrods are manufactured from chromoly steel for superior strength Pushrod covers have a chrome-plated finish Kit does not require rocker box removal Made in the U.S.A.. PUSHROD KT...

Machined from tough 356-T6 aluminum castings, the same material used to make S&S crankcases Features an inner cast aluminum cover and a decorative bolt-on outer cover Includes an internal breather passage that is used to vent crankcase Will accept either...

Kit includes four S&S Quickee pushrods, four pushrod covers and O-rings Pushrods are manufactured from chromoly steel for superior strength Pushrod covers have a chrome-plated finish Kit does not require rocker box removal Made in the U.S.A.. PUSHRODS...

Kit includes four S&S Quickee pushrods, four pushrod covers and O-rings Pushrods are manufactured from chromoly steel for superior strength Pushrod covers have a chrome-plated finish Kit does not require rocker box removal Made in the U.S.A.. PUSH...

High-powered cam for modified engines, increased compression, high-lift springs, adjustable pushrods and large bore throttle body required For best results, requires ported heads low restriction intake/exhaust RPM range 4000-6500. CAMS HO635CHN 99-06

Cast aluminum construction For V-Series Stock and Super Stock« crankcases with 0.250" offset cam chests. GUIDES TPT 84-99 BLK

Designed for 107"/114" motors, compatible with all stock valve train components Kits include all required bearings, O-rings, and hardware Capable of producing triple-digit horsepower when coupled with performance intake and exhaust system Made in the U.S...

For use with standard bearing diameter Made in the U.S.A.. SHAFT PINION 57-75XL STD

Reduced valve train noise from start up to shut down Close tolerances for low leak down rates Fast pump up and superior high rpm performance Each Precision Lifter is hand assembled to exacting tolerances and designed for quiet operation and rapid pump up...