JIMS

Remove hex nut from end of main drive gear that secures the rear drive transmission pulley Inner collar will retain wrench to nut for safer work Extra-long two-piece design Made in the U.S.A.. CNTR...

Remove hex nut from end of main drive gear that secures the rear drive transmission pulley Inner collar will retain wrench to nut for safer work Extra-long two-piece design Made in the U.S.A.. TOOL...

Smooth finish for a longer seal life 1.7" i.d. Made in the U.S.A.. SPACER TRANS SPRKT 80-84

Smooth finish for a longer seal life 1.7" i.d. Made in the U.S.A.. SPACER TRANS SPRKT 84-94

Smooth finish for a longer seal life 1.7" i.d. Made in the U.S.A.. TRANS SPRKT SPACER 94-06

Aluminum blocks have inserted Delrin« pads that rest against case to prevent marring and to support the case Keeps case level when using bearing pullers to remove balancer inner bearings Protects...

Designed to protect engine cases by using a specially-designed support block to remove or install cam side crankshaft bearing Made in the U.S.A.. T.C/C.S BEARING INSTALLER

Allows you to easily position head for all types of work Use to hold head in vice through spark plug hole For use with Milwaukee Eight engine series Has 14 mm and 12 mm ends. TOOL SYLIN HEAD HOLDER M8

Removes the risk of using the starting system to pump up the lifters or damage to the valve train at low rpm if the lifters are not fully bled Special jar, designed for vacuum, holds up to four...

Adapters are supported by a stand that makes it easy to press valve guides in and out Adapters for working on 7 mm valve guides Made in the U.S.A.. TOOL PILOT VLV GUIDE 7MM

Adapters are supported by a stand that makes it easy to press valve guides in and out A special guide alignment shaft holds the right angle for best possible guide installation Save time and money on...

Made from the highest grade materials and heat-treated to JIMS strict standards Feature a 10? lock angle Work well with JIMS titanium valve spring retainers Made in the U.S.A.. VALVE KEEPERS 84-04 BT