ANDREWS

Cams run to 6500 rpm with stock hydraulic lifters; recommend solids not be installed Stock base circle sizes allow the use of stock pushrods Made in the U.S.A.. ANDREWS N8 CAM 00-19 XL

Bolt-in four-cam set More horsepower and torque Stock springs OK to 7000 rpm, requires no headwork Made in the U.S.A. Installer must check coil bind, valve-to-valve clearance, valve-to-piston...

Bolt-in four-cam set More horsepower and torque Stock springs OK to 7000 rpm, requires no headwork Made in the U.S.A. Installer must check coil bind, valve-to-valve clearance, valve-to-piston...

Bolt-in four-cam set More horsepower and torque Stock springs OK to 7000 rpm, requires no headwork Made in the U.S.A. Installer must check coil bind, valve-to-valve clearance, valve-to-piston...

450 cam has great pulling power throughout the rpm range 420 bolt-in street cam with more torque and HP for all around riding with stock CR (1800-5200 rpm range) Made in the U.S.A. CAMS FTR INDIAN -...

450 cam has great pulling power throughout the rpm range 420 bolt-in street cam with more torque and HP for all around riding with stock CR (1800-5200 rpm range) Made in the U.S.A. CAMS FTR INDIAN -...

450 cam has great pulling power throughout the rpm range 420 bolt-in street cam with more torque and HP for all around riding with stock CR (1800-5200 rpm range) Made in the U.S.A. CAMS SCOUT INDIAN...

450 cam has great pulling power throughout the rpm range 420 bolt-in street cam with more torque and HP for all around riding with stock CR (1800-5200 rpm range) Made in the U.S.A. CAMS SCOUT INDIAN...

Pushrods fit Shovel engines using stock diameter tubing so there is no cover tube interference For stock stroke applications Made in the U.S.A.. PUSHROD CHR MLY 66-85 BT

34 teeth with ignition trigger ring Must use with 99-01 engines with stock ignition 02-06 engines can use stock rear cam drive sprocket Trigger ring required for 99-01 engines with rear cam drive...

Made in the U.S.A. This cam is the Knuckle equivalent of a "B" cam in a Pan/Shovel motor Bolt-in performance cam Smooth idle, strong pull to 6000 rpm. CAMSHAFT S 36-47 BT

One piece cold-forged fork Fully heat treated and black oxide coated Made in the U.S.A.. 74 SHIFT FORK MAIN SHAFT