Tools

Designed for installation of the swingarm bearings on late-model Japanese off-road motorcycles Kit includes driver sizes I.D. 20 mm / O.D 26 mm, I.D. 21 mm / O.D. 26 mm and I.D. 22 mm / O.D. 27 mm Includes three drivers for use with common bearing sizes...

Will not work on clutch baskets with reversed inner clutch hubs where the integrated clutch faceplate is facing outward Not recommended for V-groove or half-round-style clutch hubs Holds clutch hubs, flywheels, gears, sprockets, etc. Features 8 mm...

Will work on 27 mm-62 mm fork legs and tubes and on forks that are 140 mm to 220 mm (5.5" - 8.6") on center Quick and easy-to-use tool for aligning front forks to ensure they are parallel from top to bottom Proper alignment reduces stiction, enhancing...

Ultra-low-profile design removes pistons from monoblock disc brake calipers Fits pistons with a center bore size of 14 mm - 28 mm Non-marring design will not harm pistons or caliper Works on aluminum, steel and titanium pistons Easy-to-use single locking...

Includes Japanese Industrial Standard (JIS) cross-head bits #1, #2, and #3; also accepts all common driver bits Features 3 drive heads, one at end of shaft and 2 at each end of handle with magnets to hold drivers firmly in place High quality Motion Pro«...

Safely removes and installs the upper spherical bearing on rear shocks Reversible puller cup with cutaway fits a wide variety of shock reservoir and compression adjuster configurations Fits 24 mm OD bearings Durable brass thrust washer. TOOL SHOCK...

Used for removal of the flywheel or rotor if applicable Laser etched with Motion Pro logo and part number Heat treated for strength and durability Durable hot black oxide finish Comes with protector Right hand thread Lifetime limited warranty. TOOL...

Hex socket extends only part of the way into the socket to allow the nut to be held flush with the end for easier, hands-free starting Deep sockets allow nuts to be driven over long threaded bolts Slim outside diameter allows sockets to fit in tight...

3/8" (EU: 0,95 cm) drive male and 1/4" (EU: 0,64 cm) drive female for use with sockets for smaller front axles 3/8" (EU: 0,95 cm) square drive is rated for a maximum torque of 90 lb/ft (EU: 122,02 NM) Allows T-6 Combo LeverÖ to be used as a 3/8" (EU:...

3/8" (EU: 0,95 cm) drive male and 1/4" (EU: 0,64 cm) drive female for use with sockets for smaller front axles 3/8" (EU: 0,95 cm) square drive is rated for a maximum torque of 90 lb/ft (EU: 122,02 NM) Allows T-6 Combo LeverÖ to be used as a 3/8" (EU:...

Can be used to remove and replace small to medium internal snap rings up to 50 mm deep, including those used for transmission gear locating, bearing retention, and oil seal retention Allows removal of internal snap rings used in hydraulic master...

The tool is slotted to allow removal and replacement of caps with the P/N 11-0081 Micro BleedersÖ This tool allows removal and replacement of the accessory fork cap Versatile design features a 22 mm hex and 3/8" square drive. KTM FORK CAP REMOVER