Tools

Specific stands for top end, transmission, cam chest, and primary Part organizers for powertrain assembly, teardown and storage Stands nest to save space Made in the U.S.A.. ORGANIZER HARDWARE SET

In order to perform any type of lower end service or performance work, it is necessary to split the crankcase into halves Simply install the tool on the primary side of the case, and easily split the cases by hand with a ratchet Incorporates design...

Helps diagnose loose or spongy tappets that could eventually lead to bleed-down issues or sticky tappets that won't pump up due to poor hydraulic unit fitment Allows filling of hydraulic tappets before assembling valve train Made in the U.S.A.. TOOL...

The Milwaukee-Eight« engine returns to the single camshaft design, which requires a new tool for correct and accurate replacement of the camshaft inner needle bearing Uses the proven JIMS« style remover collet and fine threaded installation driver Holds...

Some wrist pin bushings will require a small amount of ball honing to give specified fit (see H-D manual for specifications). Used to ream wrist pin bushings to the proper inner diameter Can be used with rods in or out of the motor Lead-in taper makes it...

Used to install bearing race straight into the left crankcase A must for late-model cases Made in the U.S.A.. TIMKEN BEARNG RACE INSTER

Used to install the main drive gear without removing the transmission Made in the U.S.A.. MAIN DRV GEAR TOOL 5-SPED

Used to remove and install the inner bearing race on the transmission mainshaft Made in the U.S.A.. MAINSHFT BRNG RACE TOOLBT

Once the camshafts are removed from the support plate this tool will remove the bearing from the camshaft Removes bearing straight without binding or slipping Made in the U.S.A.. CAM BRG PULLER TWIN CAM

Accurately and safely install the inner balancer bearing mounted in the left engine case All done on a work bench without using an arbor press Designed for early or late Beta« cases Made in the U.S.A.. TOOL INSTL INR BAL BRG

Install or remove the closed-end countershaft bearing on all 5-speed or 6-speed transmissions without using a press or tapping it in with a transmission shaft Designed to install the bearing squarely and to the proper depth Made in the U.S.A.. TOOL 5&6...

For use on Milwaukee Eight series engines. TOOL LT MAIN SEAL RMVR 88