Tools

This tool can only be used for removing the flywheel from the left case Will also press cases apart and break sealant bond Some case pressing will require a hard cap Use to press flywheels from cases Made in the U.S.A.. CRNK ASSY REMVL TL 55UPBT

Consists of a vacuum-bleed device with a transparent cap which forms a tight seal to the master cylinder and has a fitting to attach a vacuum pump Cleaner way to purge the system of air with less fluid used and a reduced chance of cosmetic damage due to...

Some wrist pin bushings will require a small amount of ball honing to give specified fit (see H-D manual for specifications). Used to ream wrist pin bushings to the proper inner diameter Can be used with rods in or out of the motor Lead-in taper makes it...

Some wrist pin bushings will require a small amount of ball honing to give specified fit (see H-D manual for specifications). Used to ream wrist pin bushings to the proper inner diameter Can be used with rods in or out of the motor Lead-in taper makes it...

Gives a much better feel than a press while eliminating the possibility of applying too much pressure to the parts Provides precise installation and eliminates the cumbersome task of performing the installation in a press Made in the U.S.A.. TOOL INNER...

For use on Milwaukee Eight series engines. TOOL LT MAIN SEAL RMVR 88

Assists engine rebuilder to clear jet of all assembly lubes; verifies psi number the jet switches to "on" and visualizes spray pattern before cases are sealed Helps determine if piston jet is stuck open or stuck closed Does not include piston jet shown...

Removes both the front and rear counter-balancer shaft bearing assembly, from the left engine case Designed for the 96" and 110" Beta« engines Made in the U.S.A.. TOOL BAL SHAFT 07-08 ST

Safely installs new main transmission case bearing; does not remove bearing Holds bearing square to its bore, eliminating any marring of bearing bore Made in the U.S.A.. TOOL MAIN GEAR 07-17 BT

Comes with new valve collar receiver for safer tool usage, and can be clamped in vice Hardened ball bearing style tip at valve head end eliminates damage to valve This tool is necessary for removing or installing valves Made in the U.S.A.. VALVE SPRING...

Used on '84-'02 Big Twin to install the flywheel assembly to the left crankcase Timken« bearing Made in the U.S.A.. SPKT SHFT BRNG INST TOOL

Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case Will set bearings .023"-.028" below case surface Use to install the two inner cam bearings Made in the U.S.A.. TOOL CAM BRG INST 99-17TC