Tools

Used to hold flywheel assembly in vise, with or without left case attached Made in the U.S.A.. SPROCKET SHAFT HOLDER

Can be used on most one-piece fuel tanks that use 5/16" or 3/8" hardware to mount fuel tank to motorcycle frame Securely holds or displays fuel tank when mounted to wall stud Made in the U.S.A.. MOUNT WALL FUEL TANK MC

Slip the dog bone end of tool into the bottom side of connector until it is touching the back end of connector box Then gently pull out the male wiring connector and tool Safely removes ignition switch wiring connector Made in the U.S.A.. TOOL IGN SWITCH...

Will position the seal evenly into the exhaust port of head Tool can be used with exhaust flange nuts Made in the U.S.A.. EXHAUST DRILL PLATE

Mounts in vise to hold fork firmly during repair without causing damage to fork assembly Holds fork legs and tubes for easy hands-free servicing or rebuilding Use on smaller 28 mm or larger fork tubes with a maximum 2ö Will not scratch finish Made in the...

For '91-'03 XL applications, compressor nut must be used in conjunction with compressor tool Used to release clutch spring so retainer ring can be easily removed and installed Made in the U.S.A.. CLUTCH SPRNG COMPRESSOR

A must-have tool for 45A charging systems; will also work on any Harley-Davidson« alternator system that has threaded puller holes Tool protects threads on sprocket shaft from damage while pulling rotor free from its magnetic hold Made in the U.S.A....

Rotates flywheel/piston assembly with engine still in frame or on a bench The perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearances Also can be used to keep the flywheel assembly from rotating when...

Rotates flywheel/piston assembly with engine still in frame or on a bench The perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearances Also can be used to keep the flywheel assembly from rotating when...

Removes transmission door with gears and shaft attached Puller will not damage door bearings Made in the U.S.A.. 5-SPED TRAN DOOR PULER

Easily aligns and installs starter jackshaft seal without distorting or damaging seal Seal is located in upper part of inner primary of Big Twins Made in the U.S.A.. TOOL STARTER SEAL 94-06

Designed to remove and install bearing cups in cast wheels Use with JIMS« Handle. RACE REMOVER & INSTALLER