Tools

Assists in the disassembly and assembly of springer-type front forks on Harley-Davidson motorcyclesMade in the USA

Facilitates loosening and tightening of hard to reach rear axle nut on H-D® baggersFits 36 mm axle nutsCaptive swivel extension with ½ inch driveRated for up to 175 foot pounds of torqueDurable plastic sleeve protects exhaust systemLifetime limited...

Kpmi Installation Protector 5/16" Evo & Ironhead Intake 20-20637

2-in-1 design precisely removes and installs outer bearing raceQuickly and precisely remove and install outer bearing race from the steering head on most Harley-Davidson® models without the use of a hammer and punchPuller design ensures bearing is pulled...

Pushrod tube holder makes for easy adjustment of adjustable pushrods, holding pushrod tubes up and out of the wayMade in the U.S.A.Fits EVO, T/C and most aftermarket tubes

Durable impact-resistant carrying case with molded foam interiorSpring-loaded gun device that drives the tire plug into the holeThe shaft of the tire plug expands under pressure to fill the punctureThe mushroom head of the tire plug seats on the inner...

Set uses a split collet design to remove radial ball bearings on Harley-Davidson and American V-Twin motorcyclesAll 2007 Softail models (exc.Springer models) use a 25mm radial ball bearing on the front wheel

Kpmi 2/Pk Install Protector 5/16" Evo & Ironhead Intake 20-20634

A. 2¼" Round tire patches, works with radial and bias ply tires, vulcanizing cement required for use, 50/sleeveB. 2¼" Round quill type tire patches, works with radial and bias ply tires, vulcanizing cement required for use, for repairs in the tread of up...

For use with motorcycle and ATV tire repair kits

Kpmi 2/Pk Install Protector 3/8" Pan & Shovel 74" & 80" 20-20636

Used for tappet block and oil pump alignment (2 required)1/4"-20 thread