JIMS

Very simple tool, just mount tool in cover, screw in the two removing screws, turn center, and out comes the cam seal The new seal is then pressed in with the same tool, square and flat for a no leak...

Used to remove and install the main drive seal on specific Harley-Davidson« Big Twin models Made in the U.S.A.. 4SPD TRNS MN SL TL36-76BT

Helps to guide the front wheel track into the correct position on bike lifts Fits most bikes lifts with a front wheel vise Made in the U.S.A.. LIFT, BIKE WHEEL GUIDE

Prevents damage to pistons and cylinders when installing new seals and wipers Holds pistons square in their cylinder bores during removal Designed for front and rear 4-piston calipers Made in the U.S...

Use on all bushings These pins hold bushing in place Made in the U.S.A.. STAKING DOWEL PINS OEM275

Use to check pinion gear for pitch diameters Check service manual for sizing chart Made in the U.S.A.. CAM PINON GAUGE PNS 105

Use to check pinion gear for pitch diameters Check service manual for sizing chart Made in the U.S.A.. CAM PINON GAUGE PNS 108

Holds both cams in an upright position while lowering cam support plate over both guides and cam journal guides Made from a non-marring material that will not damage any of the cams' surfaces Made in...

Use to check the alignment of cam bearing to cam cover bushing to within .0003" of centerline Binding of tool indicates misalignment of cam cover and bushing Made in the U.S.A.. CAMBEARING ALIGNMENT...

Designed to press from the letter side of the inner cam bearing to eliminate any damage to the bearings, cam or case Will set bearings .023"-.028" below case surface Use to install the two inner cam...

Once the camshafts are removed from the support plate this tool will remove the bearing from the camshaft Removes bearing straight without binding or slipping Made in the U.S.A.. CAM BRG PULLER TWIN...

Use to line ream cam cover bushing to size, from inner cam bearing, for a true center line between the two dimensions Finished size will be .0008"-.0015" over the cam journal Made in the U.S.A.. LN...