JIMS

Installs transmission shaft without the use of a hydraulic or arbor press Made in the U.S.A.. TRNS SHAFT INSTALLER

Remove hex nut from end of main drive gear that secures the rear drive transmission pulley Inner collar will retain wrench to nut for safer work Extra-long two-piece design Made in the U.S.A.. CNTR...

Smooth finish for a longer seal life 1.7" i.d. Made in the U.S.A.. SPACER TRANS SPRKT 80-84

Smooth finish for a longer seal life 1.7" i.d. Made in the U.S.A.. SPACER TRANS SPRKT 84-94

Smooth finish for a longer seal life 1.7" i.d. Made in the U.S.A.. TRANS SPRKT SPACER 94-06

Designed to protect engine cases by using a specially-designed support block to remove or install cam side crankshaft bearing Made in the U.S.A.. T.C/C.S BEARING INSTALLER

Allows you to easily position head for all types of work Use to hold head in vice through spark plug hole For use with Milwaukee Eight engine series Has 14 mm and 12 mm ends. TOOL SYLIN HEAD HOLDER M8

Made from the highest grade materials and heat-treated to JIMS strict standards Feature a 10? lock angle Work well with JIMS titanium valve spring retainers Made in the U.S.A.. VALVE KEEPERS 84-04 BT

Valve spring collar allows existing compressor to remove smaller valves on M8 engines For use with JIMS« Valve Spring Compressor Tool (PART# DS-196013) Made in the U.S.A.. TOOL VAVLE SPRING COMP M8

Used to remove and replace valve and new-style conical valve spring Requires use of JIMS Valve Spring Compressor Tool Made in the U.S.A.. TOOL VALVE SPRING 05-17

Comes with new valve collar receiver for safer tool usage, and can be clamped in vice Hardened ball bearing style tip at valve head end eliminates damage to valve This tool is necessary for removing...

Incorporate an interference double-spring design with damper to control harmonics Engineered for maximum performance in severe applications such as high compression and big-inch street motors 0.600"...